600w coolshade, Fan Kit, 1.0m Tent Set-Up help

[v1nc3]

hi ive just recieved my new growtent with 600w bulb and a coolshade with an Extraction Kit consisting of an RVK 125mm Extractor Fan,10m of 127mm flexible ducting & a Re-fillable CF240 125mm Carbon Air Filter can some help with this setup as it came with no instructions the fan needs wiring up how have u guys got yours setup so the cool tube actually works with everything else can some 1 plz show a diagram been looking on net but no luck
thanks

does the carbon filter need to be in the tent or out where do i put extraction fan?

[StonerGrower]

6oowatt MH or HPS?

Im not sure if we have a tuturial on how to wire, but I WILL do some searching for you! So Ill get back to you on that...

The caron filter doesnt have to be inside the tent. You could deffinatley keep it outside, in fact thats way more efficient...Takes up less space in the grow room. I push air through my carbon filter...So I have clean air intake into the growroom, all exhaust air goes through the carbon filter.

[v1nc3]

thanks for reply the wiring is sorted found some diagrams in the end

ive set up my carbonfilter etc like this not sure if any good thru
carbon filter ducting cooltube ducting (extractor fan outside tent) this pulls tent in with the pressure ov fan pulling air throu carbon filter do u think this is ok or will be ok?
again thanks for help

ps.ive been looking at envirolite timers with built in contactors have u had any experience with these as i only have 1 light in tent and seems better option than contactor/relay box cheaper 2 but would like some info experience with these timers (any1) still have a few bits to get lol but getting there

600 watt hps bulb for flowering have seperate space for vegging with 250watt envirolite bulb