My wife and I both have our cards. She has an exemption that the doctor wrote out for "20 mature plants" because she has cancer.
I remember at one of the MMJ shows in L.A. in September ( I think it was HempCon) one doctor was willing to write recommendations for 50 plants.
Anyone know who...
Well I had a good run this past year and learned a lot. I have another problem though.
I have a clone off of a strain that was the best I could grow. But for some reason this clone has round leaves. Now this is weird.
I first had the clone in a hydro setup, but that seemed only to...
Unfortunately no one was able to give me any insight to how the plants would react if taken from a 1000w HPS back to a T5 light.
I did this however and the result is that there was no adverse affect at all. It has been about two weeks now and the plants are growing normal without any...
I over compensated and cloned too many plants. I figured since I was just starting out I would need a bigger margin of error and fewer died than I had expected.
I got lucky and now I have a forest in my grow room. My room is about 12x8 and I have been using a 5x8 area curtained off for...
Well everything has been going better for my first grow. I initially had some mite problems, then a little nute burn.
After my harvest I am going to be making some changes to my room. This last time I had a 1000w hps flowering 10 plants in a 4x8 area. I felt they were a little crowded and...
I have a plant, its doing good. I switched out my t5 and replaced it with a 1000wHPS last night. I feel like the thing has grown an inch over night. I actually measured it and the tape show that it has, but the plant could just be standing up straighter.
Regardless, my new question has to do...
Is there any correlation among the health of a plant and its leaves.
I have some plants that are 10" tall from the top of the container and they have these massive leaves. I have been vegging them from clones for 3 1/2 weeks under a t5 and today got a 1000w hps for them to veg under.
I ask...
Other than manufacturing quality, are all LED's the same? Meaning, are there so few manufacturers of the actual LED component that all red LED's are of similar quality, deliver approximately the same spectrum, and put out the same amount of light (maybe called luminosity for LED's)?
For...
I would think the only savings would come in two forms. First, the heat factor and not having to cool the grow as much. Two, from the potential longevity of the lights and not having to replace bulbs.
Wish these lights were less expensive.
re: GLH 600W LED Grow
Oops, sorry to give the impression I was comparing your previous grow and this one. I had meant to talk about the difference in the quality of lights from your previous grow, and the quality of the light from this grow.
Regardless, you did answer my question. Going to...