Well I have the DS18B20 Temperature probe reading accurately without a pickup resistor.
I also have the DHT22 sensor reading great.
I am awaiting my PH probe so I guess the next step is to setup a relay for the on/off control of my LEDs.
Time for google again I guess.
Yes I have read tons.
I installed the libraries and I am trying to run the DHTTester
I get the following;
Arduino: 1.8.3 (Windows 10), Board: "Arduino/Genuino Mega or Mega 2560, ATmega2560 (Mega 2560)"
\Documents\Arduino\libraries\DHT_sensor_library\DHT_U.cpp:sleep:0...
Been reading about this.
I'll share the code and a photo of my setup as I have no idea what's up.
It gives -999 which I believe means nothing is connected.
I did have humidity of 2 and temp of 0 at one point.
Well I finally returned home.
After several hours of failed attempts at getting my dht22 to give a reading I'm retiring for the evening.
Tomorrow's another day.
Been on the road but ladies are stretching.
Gave them a pinch to keep from getting too close to light.
I have been running both nutrients according to feed schedule.
Currently @ 75% of recommended.
I See zero difference other than initial cost at this point.
Well the mega, shield, breadboard, and 3 x temp sensors have arrived.
Played a bit today with getting libraries installed.
I'm on a week road trip so hopefully I can buckle down when I get back.
I love my COBs.
Out perform purple.
I'm pretty happy with my quantins too.
I ran all CKS and their service is good in my experience.
I am now running autos just since my wife stole my veg tent for our garden.
Next will be Bergman.
I'm told he has great strains and they accept credit cards.
I've made them as well.
The biggest change has been the method and changing out butter for coconut oil.
Far more potent.
If you have kief watch out.
It's deadly.