Darn , just start over right?

[corinth]

So power went out in my clone area for bout im guessin a day 2 tops. So had a few cuttings i started cloning a week ago in a auto cloner. Arr those cuttings gone? Use basic clone x gel for the cuts and the clonex liquid for the cloner resvoir. With some t5s the whole shabang. Wouldnt be a problem to take cuttings again just do i need to? Appreciate any advice.

 

[Bionic Chronic NZ]

Just leave it under 24/7 light and it'll settle down into veg mode. It will be slightly out of sync but all will be well.

 

[Lightworker81]

Cuttings and vegging plants should be fine. Flowering plants with a day or two power outage might be an issue.

 

[corinth]

Ah ok yea i was just thinking cause i know if fresh cuttings sit out of water for too long they develop air pockets that kill em.

 

[TurboBucket]

Depends on what the leaves look like. If they haven't drooped they're fine. If the leaves have wilted too far they won't come back.

 

[Weaselcracker]

if fresh cuttings sit out of water for too long they develop air pockets that kill em.

This is a myth put that way, but they can dry out obviously. Should become obvious though whether they’re ok or not. They can sit a long time with the pump off as long as their stems are in a very humid environment.

 

[Bionic Chronic NZ]

Post a pic up...

 

[corinth]

Stoner move really forgot that sockets sensitive.

 

[Weaselcracker]

They’re fine

 

[corinth]

Ah ok thx for the knowledge.

 

[corinth]

Ak 47 heh olmost done i think super sweet sticky.