Ebb&Flow bucket system with control bucket outside 4 X 4 tent

[jnt62]

Hey Everyone

I will be starting mt 2nd grow with the same system:

Hydrofarm — Active Aqua Grow Flow Ebb and Gro Controller Unit w/2 Pumps

hydrofarm.com

Active Aqua Grow Flow Expansion Kit, 6 Pot, 2 gal

Grow Flow Expansion Kit, 6 pot, 2 Gal

hydrofarm.com

.

The problem is where the fill/drain lines enter the tent.
The lines must rise off the floor to enter the bottom of a tent vent port.
This resulted in water remaining at the bottom of the pots.
I figured the solution is to raise all the buckets.
I thought there was a chance that someone had found a more elegant solution. (with this huge wealth of information)

Thanks for taking the time to read my post
JNT

 

[jnt62]

I found these. They should raise everything up enough.

 

[Latitude17]

I've got a setup using this system, I used some 19mm or 3/4" metal (not rubber!) grommets to solve the problem. The hardest part was the mounting process (required a helper), but very please with the results. I put them just above the included 2" flooring insert and just below one of the factory closable 8" holes in the corner. Keeps the control bucket in a cool place as well.