Monster Cloning & Seeds, LEDs, Promix & Soil
- Thread starter Lowded118
- Start date
-
- Tags
- ×lowded118
- Thread starter
- #983
@Kingjoe83 yhanks bud what do you suggest 700ppm again? I finally saw burn on everyone’s but the calibatdream and sour d
What week flower buddy photo me right my bad old brain
That's a shortcut that means I agree with the post above.
If 900 causes tip burn then 700 should be good.
- Thread starter
- #986
Good advice
- Thread starter
- #988
Lol yea I haven’t fed that high since I came here.
A great mentor of mine here said once less is more I truly believe that and more frequently is key . back off dose 700 could be okay 650 is coo too
Which means you could even push those other two to see where they like to be ?
I rarely go over 600 or so and that's in full bloom.
More light means more nutes but the plant can only use so much nutrients, anymore than what it needs will lead to issues.
See I am a firm believer one should push a plant a little to see what it likes and where it’s limits are. Then I suggest backing off immediately so don’t Push if don’t need to .
Makes sense
- Thread starter
- #997
Awe guys, this makes sense, when I was feeding low and once every week or more, trouble, I guess if I choose to soak promix mix nutz higher if I’m feeding daily, feed lower ppm. Same but different.
Less but more essentially brotha
In coco I feed fairly light but I'm feeding daily too, I can always increase nutes if they start to look pale but once you burn them the damage is done.
In soil I feed every time I water which depends a lot on the stage the plant's in. I don't split up the feeding based on # of times a week. I do check runoff though and back off if it gets too high or the plant shows brown tips.
Similar threads
