Spare Driver

[423]

20190323_005946.jpg

• 423
• Mar 22, 2019

I Have this spare driver and want to add more light.

 

[423]

20190323_010427.jpg

• 423
• Mar 22, 2019

 

[423]

I used one to run two 1212's 80cri 3000k gen6. And have an extra.
Would that work for any boards or strips or just more cobs maybee.

 

[423]

Any input? Ideas on this?
Im pretty lost on using a multimeter but heres what I got checking while hooked up to two 1212's in series.
.7A
35-40 volt.

 

[423]

This was in a morsen cob led.
Originaly I hoped i could just change the cob chips leaving one driver per chip the way it was.
When i removed the blurple chip and added the 1212 with holder it would flash on and off and wouldnt run steady.
I ended up wiring two 1212's in a series and it works steady but doesen't seem that bright.

 

[423]

Would this be safe to run without the active cooling fans on?
I think it's running on pretty low power. If i measured the power corect its about 24.5 watts divided into two cob's. Just over 12 watts a peice.