Hello everyone,
I"m converting my LP system to a HP system. From reading various forums, I gathered that I needed to by nozzles with an orphice of 0.024" and a pump that can do anywhere from 80 to 100 PSI.
These specs where suppose to put my droplets in the 50 micron range. Instead i get a jet type output rather than a fog or mist. I get fog of some sort once the jet stream hits the other side of my pale.
I'm assuming I should have ordered a smaller orphice for my misters, like a 0.010" or smaller for the PSI pressure I'm using, but I don't want to order another bunch of misters if this won't work once I try it.
My misters are 0.60mm/ .024″ STAINLESS STEEL MISTING NOZZLE — (Cleanable)
My pump is an Aquatec 8800 RO Booster Pump
Can I get advise on what to buy for this to produce 50 Micron droplets? I can replace the pump if needed or the nozzles or both if necessary.
Any advice?
Thanks
I"m converting my LP system to a HP system. From reading various forums, I gathered that I needed to by nozzles with an orphice of 0.024" and a pump that can do anywhere from 80 to 100 PSI.
These specs where suppose to put my droplets in the 50 micron range. Instead i get a jet type output rather than a fog or mist. I get fog of some sort once the jet stream hits the other side of my pale.
I'm assuming I should have ordered a smaller orphice for my misters, like a 0.010" or smaller for the PSI pressure I'm using, but I don't want to order another bunch of misters if this won't work once I try it.
My misters are 0.60mm/ .024″ STAINLESS STEEL MISTING NOZZLE — (Cleanable)
My pump is an Aquatec 8800 RO Booster Pump
Can I get advise on what to buy for this to produce 50 Micron droplets? I can replace the pump if needed or the nozzles or both if necessary.
Any advice?
Thanks
