hahaha thanks man !!
Thanks man !! It’s hard to make up my mind on what to use because every chart is so different.. with the « expert recirculating » chart it states that I should use 400-600 ppm for seedlings and 1000-1200 ppm on week 1, that seems excessive doesn't it ?
For now i’m at 1/1/1 for grow micro and bloom (15ml each) so 1ml per Gal. Perhaps that’s too high for their size..
thanks for the advise i’ll defenitly add an enzyme cleaner !
Thanks man i’ll drop the PPM and follow your advise ! Would you happen to have the feed chart you used with flora...
I dont know the % but i’m at 450 ppm total,
I started using Armor Si since a week at 1/4 strenght.
I mix in this order:
PH, ArmorSi, Cal mag, micro, grow, bloom, PH again if necessary (5.8)
I’ll try to drop water level, thanks for the tip :) should I use hydroguard ? I’ll go read on it. Could...
Thanks for the reply !! Water level is an inch under the net pot and roots are already 10-12 inches long so they reach easily. All white with no root rot...
Thanks for the reply Chris, water is an inch under the net pot, good bubbles with a 4 inch circular stone, roots seem very happy and...
Hi all !
It’s my first time growing in DWC and I’m facing a problem I can’t resolve..
Nutes:
General Hydro
Ratio for week 1-2:
Micro 1
Grow 1
Bloom 1
Cal-Mag 4
PPM at 600, too high ?
water temp 68
light 320w QB Light 24 inches above
PH 5.8 - 5.9
I have 3 plants and they all react differently...