I can't believe... I had to respond to this post. It's been so long. I'll post you a pic of my heatsinks, but I gotta explain the story first.
So it was my idea to fire up the room again since I had not done it in a while. But here's the thing... right after I made this post about this...
I'll set it up for a four board but only wire it for three on the meanwell hlg-240h-c2100b. Custom frame. I'll post photos in a few days. I threw the other two outside. One blue skywalker. My strain and a pinapple kush.
I totally agree with you... this is why I do not understand why the boards blew. I had three on one driver. 6 on the 480 h dialed down to basically 66% of allowed wattage. I had heat sinks of aluminum boards on top of them recommended by one of the members here. Old school. Brain fart on his...
Well. It went a whole run with all of those boards in a nine pack with those drivers. All I saw as far as a fire hazard was more diodes burning out.
Yea.. it was a one time by. Total waste of money.
My question still stands on whether or not my voltage is right.
Guess I forgot to mention that...
I gave up on doing this for a while. I was trying to start my own company and gave up on growing for a while because of multiple reasons including...
So i have 9 boards that are 11 1/4 x 6 7/8's, with 312 samsung 561c's 3000k.
I ran 3 on a meanwell hlg-240h-c2100b
6 on a meanwell...
You do know. Geez. If I would have known all of this 20 years ago.. pfft. I wouldn't torture half my chicks for fun just to mess around and get the science behind it.
Alright. Tried to get a photo of the roots, but it didn't work out so well. At least you guys/gals get some cheap beer out of it.
Then you can see my mainline system that because I wasn't paying attention is not working out so well. This will be funny to see how these hybrid mainlines work out...