Recent content by jnt62

Hello Folks, I had to move up to a larger extraction fan because my new light produced more heat. I went from 6" to 8" fan with the expected increase in CFM. I have a 20degree swing in the room my tent is set in. I need a fan controller that with a temp probe can adjust the variable speed. Is...

The humidity has not reached 50% and the reservoir, temp stays close to 68F The Inkbird looks like it will do the trick. I have to make a correction before the next grow. I like "set it and forget it". I have to believe that the heat is responsible and I missed it because of inaccuracies in my...

@Drillerjoe @Nunyabiz @RetiredRN Sorry for the slow response. Here are a few pics of this travesty

@Drillerjoe ... This light isn't dimmable, at least not to my knowledge. The temp did get up to 81 2 0r 3 times until I was able to channel some cooler air towards the tent. I am thinking that may have caused my problem.

Hello folks, I am nearing the end of my 2nd auto-flower grow. I purchased a new light for this grow. california-lightworks-solarxtreme-1000 I have a 6" 450 CFM inline with a carbon filter and 2 clip-on 6" oscillating fans During flower, all of the top leaves turned yellow and died. I have...

I found an article about this and it recommends using H2O2: Rapid Rooters & white fungus. The seedlings are looking good. I learned to not overwater Rapid Rooters.:rolleyes: It looks like I'll have 2 harvests a couple of weeks apart. I don't think I'll have any more problems with Rapid...

Thanks for responding. I attached a couple of pics since you responded. Being relatively new to growing I get concerned when I see something like that. Thanks again for chiming in.

Hey Folks This is my 2nd grow and the 1st using Rapid Rooters. After 3 days in the propagator, there is a white dusting to be seen on top of the Rooters. Do I have a problem? If so is there something I can do for it or should I start all over? 4 of the 8 seeds have popped up. I soaked the seeds...