Recent content by oxenhiven

I've been struggling with my plants for a while and coming here was my last resort, but I figure I could use some outside insight. First off, this is my first grow ever. They've been vegging for about a month. I have 6 plants in 5 gallon pots and 1 plant in a 3 gallon pot. I think I may have...

Vegging for about a month, plants have drooping leaves, yellowing edges, some curled up, others drooping

Vegging for about a month, plants have drooping leaves, yellowing edges, some curled up, others drooping

Vegging for about a month, plants have drooping leaves, yellowing edges, some curled up, others drooping

Vegging for about a month, plants have drooping leaves, yellowing edges, some curled up, others drooping

Vegging for about a month, plants have drooping leaves, yellowing edges, some curled up, others drooping

I did think of doing this, and after considering everything, it will probably be what I end up doing. I guess either way, I'll still be dealing with a bulky filter. It's not really a necessity for me to make it smaller, I would just like more room for my plants to grow. Thanks for your input.

I made a carbon scrubber from scratch following a tutorial I found on another site. It helped me out a lot, since I'm on a tight budget, but now that I've finished it, I'm beginning to wonder if I made too big for the setup that I have. The scrubber itself is 8 inches in diameter and about 2...

I'm not sure why, but I can't seem to edit my post so if you've come here because you have the same problem, I found a solution. Earlier, I mentioned that I would vent all the heat into the garage. At first, I was afraid of doing this. Mostly because I didn't want to vent all the cold air in...

Smell has yet to be an issue, but I do have a carbon scrubber ready for it when the time comes. As far as the fan goes, putting it in the garage (or just above it in the attic) was exactly what I was thinking of doing. The only question I have is, Is this going to affect the cooling in the...

This was my very first idea, but I read somewhere that venting directly into the attic may be dangerous because it increases the humidity up there, increasing the chance of mold on the framework. Also, I've tried looking up this idea and apparently it's a subject the entire internet wants to...

First time posting, so if I get something wrong please bear with me. I have a spare bedroom where I've made a DIY grow tent. It's not pretty, but I think it will do the job. The tent itself is approximately a 4x5 with a 1000w HID. The tent itself is made from panda plastic with the frame is...