Recent content by scruffy420

No problem man. However, I went through last night to refresh myself on the hyperfan. Looks like it doesn't come in a 4". 6 is the smallest they have. There's a YouTube video on it, if you'd like to check it out. But, basically they tested it out, and it actually draws 55w, with 315 CFM. Which...

Well, to start off, are these rooms physically separated by walls, or are they just partitioned into different sections? If the rooms are basically air tight from the outside, it makes it easier to ventilate each room individually. If they are open air, it would probably be easier to just run a...

I'm not entirely sure. I would have to assume so, since that occurs in nature (forests, etc.) however, I can't actually grow right now. What I can tell you is that I've heard that, during flower, humidity at 40-50% is normally okay, I think the best value is somewhere around 60%, and above 60%...

First question: Do you have an actual like fabric tent? If so, use tape for what I'm about to say. If you are using a wooden box, cabinet, or room in general, nail it down, or build a little holder for it. My advice is to simply go online and look up HEPA filters. If you're not looking to...

Hey, if you're still having humidity issues, you might look into just setting up a 1-room sized humidifier in the room that your tent is in. If the whole room gets to 70% humidity, the air in your tent will be at 70%. Also, you could take the little humidifier that was suggested earlier in the...

I can tell you that for stealth, the phresh hyperfan has gotten rave reviews. comes in 4,6,8,10" varieties. the 4" pulls 35 watts (super low), and pulls 135cfm, if I remember correctly. I would also suggest buying some ducting wrap that has insulation on it, as it reduces flow noise inside and...

You might look into diy led panels. Look up greengenes garden or growmau5 on YouTube. The newer chips are reallly good, but are kinda expensive. I'm sure you could get some older cxa chips or something that will work just fine, and will cost quite a bit less. They get some awesome harvests from...

Hey man, just letting you know that I'm pretty sure there's a slight issue with the math on those lights. The Sun Blaze says it's only 54w, but I'm pretty sure that the 54w is per bulb. Both are 8x T5HO bulbs, so I would have to assume that they are the same wattage. Also, both say 40,000...

It might be good for you to check out growmau5 on youtube. He builds DIY led panels. I think a couple of COB leds would push your tent really far. you could easily build two small panels (2 cobs each, I'd say) and hang one on either side of your HPS. If you drive them at around 1400ma, that'd be...

I agree. Like, I mentioned, picking drivers is no problem, really. All of my electrical components will have dimming with the exception of the cfls. Not all of the lights will be on, at a time, anyway. The flower initiator LEDs will only be on for about 15 mins a day, and the UV will only be on...

This is the picture that I've drawn up for the layout. Hope it helps!

This is a bigger, hopefully more visible, picture of my 2x2 flower room light.

This is the layout for my DIY LED panel for my 2\'x2\' flower room.