Recent content by WattSaver

I use a ratio of 1 1/2 tbs / gal of medium. In a 2gal hempy I'll use 3 slightly rounded tbs. When growing pot you need more than the recommended container amount, because it's rate of growth is much higher than your normal houseplant.

I still use it for all my indoor hempy buckets. As I've gotten older and lazier it works even better for me, and the results are always good.

I'm sure that both products use very similar technology. For yrs I operated my grows very similar to the way your going. With a veg box in the grow rm using clones from previous grow or new seeds for the full flower duration. I found the easiest way to do this was to veg in 1/2gal soil pots then...

Ive used Osmocote for almost 10yrs now but never used Nutricote before, I looked it up and I like the different duration times don't think you'd want to use the 360 or 180 day stuff. Did you get the product with the micro-nutes? I've found that OC works extremely well in hempy buckets. I'll be...

I want the Mars Hydro TS-2000, because I have heat problems during the summer months with the hps

I've never seen an Either extract before. I goggled the price and that shit ain't cheap. Do you use a sealed system to recycle the either? By freezing material are you trying to keep the either close to a fluid state? Very nice looking wax may have to lean more about Dimethil Ether extract.

You are absolutely correct, no matter what solvent you use, Patience and letting evaporation work over time results in the best product. There are so many terpenes that are lost at temps well below the vapor point of the oil.

As far as flowering. As mentioned she looks to be mainly sativa, so if you want it to start flower now just reduce the light on time down to 10 or 11 hrs. If you go to 10/14 it will start to flower, otherwise at 12/12 it will continue to veg until it's ready to switch, which could take 6 months...

First pull the 2 main branches above the split together, use string wire or tape, then use some electrical tape and wrap around the split. It will recover. Main thing is to relieve the tension from the split area.

This was a tutorial I posted a yr back on a site that doesn't exist anymore. Clean Butane Extract Without Heat or Purge I’m a person who will exchange time for labor, but won’t accept inferior product. I have in my possession a few blasting utensils, and a good purge pump, which hasn’t run...

Don't worry about picking up any chlorophyll. I do my soaks for 10 to 20 mins. I even did an overnight soak once. Plant material / chlorophyll is a very polar substance, and water is the most polar of all solvents, so water is the biggest culprit in pulling chlorophyll. Butane is a very...

Hey S1ingblade, this Teflon paper, do you think it would last during a thin layer air dry that could take a wk? Does the paper seem to get wet during the butane evap? It would be great if I could take the pan scraping out of the production. Question about the closed pressurized blaster, I...