So sometimes when my light turns on it comes on for a bit and then goes dead. Only way to get it back on is to unscrew the bulb and screw it in again. Then for some reason it works again. Has anyone dealt with these issues? Not sure where to go from here. well any info would be great. good buds all.
Bulb or socket issue?
- Thread starter laroobien
- Start date
Not sure, I have not had that problem.. I always keep a back up bulb around....
- Thread starter
- #3
Yea i bought it used and then bought a new bulb but when it arrived it was cracked. I couldnt wait so just been using the one in question. I twould think the socket cause the bulb seems to keep working after an unscrew. This last time seems to put out more light and therfore more heat. Is there away it should be screwed in. The flat part inside the mh bulb is sideways and used to have it flat, if you know what I am talking about. Didnt know if that matters. I should of bought new but this was a good deal so went for it.
I was going to guess socket too.... It does not matter, just screw it in until it's tight...
- Thread starter
- #5
O.k yea I will just contact the makers of it and see what they have to say. Thanks Be Irie.. Hows Co treating you? Lived in Durango for a good stretch. Great town.
