Well got the RO back up and running finally and that alone has brought down the ph to 6.7 alone which I'm super stoked about so hopeful this is the beginning of the end of nute issues!!! Hopefully!
I've always done most of my gardening outside and everything has always done beautifully great! So now inside is a whole new ballgame and totally different.
Ak I feel you on it seeming like plants no the season even though they're not out in it. It's pretty wild. Everything sounds good everyone thanks so much for the tips. Also was wondering has anyone tried using the clearex made by several companies I tend to use nutes by FF and Botanicare so...
Hello all Sorry been a bit since posting!! New good news and a little bad, ended up losing one plant and one came back with a vengeance and is flowering beautifully. Will post pics later. Just have a question I feel like I'm having an awful lot of problems with nutrient deficiency or nutrient...
So as time has gone by I have seen some improvement but now over the past 2 weeks they have done nothing but get worse again the left plant has no hair is left on it at all. The plant on the right is losing all of its leaves but it still has hairs but they are diminishing. I have fat I have...
Temps are at canopy level and light is 36" above tops. And I always clean them out just took pics before taking them out. And for ph I check every time just to be sure. Thank you for all the advice! Helps reassure me I'm doin the right things.
Right on, I'm glad I had the help to hopefully figure it out quick and still early in flower as its only about 3 to 4 weeks, later than I would have liked but hopefully not to late. I'll keep posting and adding pics of, let's hope, some rebuilding beauties!! Thanks everyone!! Grnthmb
10-4 All my elec is from the top as well, thanks so much for everything!! I did another flush with pure distilled water and have been using it only. I would like to say I'm noticing a lil difference and some new hairs but I hope it's not just optimism!! Thanks again!!
The back wall is s conc. Block wall but I built up 3 inches off the floor and completely encased it except the back wall. Is this ok, or still same issues? I was hoping that would be up off the floor enuff. The cabinet temp runs +\- 76 to 78 F lights on and 65 to 70 F lights off. Let me know...