LightMedic
420 Member
I found a great box at Canadian Tire that makes a good 12 site cloner. I made one before, but it leaked. This one has a silicone gasket on the lid. It does not leak.
I used a 1 3/4" hole saw to make the holes for the foam inserts which I picked up off amazon.
I recycled the pump, airstone and sprayer manifold that I made from my last cloner.
The size is perfect for me.
I used a 2 1/4" hole saw to make a hole in the side for cables ect. Then used a bit of 2" abs pipe to go through the hole and glued fittings in place.
Feedback please.
I used a 1 3/4" hole saw to make the holes for the foam inserts which I picked up off amazon.
I recycled the pump, airstone and sprayer manifold that I made from my last cloner.
The size is perfect for me.
I used a 2 1/4" hole saw to make a hole in the side for cables ect. Then used a bit of 2" abs pipe to go through the hole and glued fittings in place.
Feedback please.