Ebb N Gro x Fem Bigbud

[lunderwood]

OK guys thanks for tuning in, this will be my first grow. im starting out pretty big for my first grow with the CAPs Ebb N Gro Flood Drain system.

I plan on using:
1 4x4x7 ft grow tent
1 CAPS EBB N GRO system set up to run 6 pots(50 gallon res)
1 600w cool tube hps/mh light w/ dimmable 600 w ballast
Nutes(undecided, but im thinking of using fox farm big bloom set) any suggestions are highly recommended.
6 SGT(Sure to Grow)8" inserts
6SGT1.5x 1.5 Grow cubes
1 4"Inline carbon filter/Air Blower
1 6" Inline duct fan for extra ventilation
1 16"oscillating fan


things needed/undecided:
PH/PPM Tester
c02 tank & regulator
R/O system
I think that will be all things needed for this grow to be successful. im leaning towards doing this grow without c02 tanks and reg, also without the R/O system due to finances -_-. is this a bad idea , or is it still possible to sustain nice huge colas without them?

Again thanks for reading, i will post pictures of the setup once its assembled. hope you guys give me some good feedback/suggestions im really excited to get started with the CAPS EBBNGROW.

 

[dadums]

Nutes BNP all the way. Everyone is getting great results, good service and reasonable prices. Best of all He is a 420 sponsor and is VERY helpful. He follows the Journals and chimes in from time to time.
Blue Planet Nutrients

 

[dadums]

As a new grower I'd keep it on the simple side.
PH/PPM Tester
a must
c02 tank & regulator
I'd hold off till after a successful grow
R/O system
Unless you have great water With the amount you'll need
this is a must. Just remember you'll need to add back in cal/mag.

Everything you need to know is here just read read read.
You can find journals that will show what to do and not do.
Most important people that will answer questions.

 

[lunderwood]

ok so i have an update:

instead of going with the EBB N Grow set up as stated previously im going with:
12'7"x 2'7'x 5'3" grow tent
11 inline fan/air filter combo 400 CFM
1Hydroponics/Aeroponics system w/ 35 gallon res and 6 inch mesh inserts
1600w cool tube hps/mh light w/ dimmable 600 w ballast
6SGT(Sure to Grow)8" inserts
6SGT1.5x 1.5 Grow cubes
116"oscillating fan

I have a question is it possible to block off one end of the cool tube with flange and seal the off the back of the flange, i will have the other end of the cool tube being exhausted through a 6 inch duct / 400 cfm inline fan and filter.
also would it be possible to place a wye duct in between the cool tube and the inline fan, thus keeping the cool tube cool and exhausting the stale air in the tent . i have so many more question s but ill start with this one. ill have pics up as soon as i get the system set up

 

[Happy Kitty]

How did this grow turn out?

We would love to be updated with some pictures and info!

How about posting a 420 Strain Review?

If you need any help with posting photos, please read the photo gallery tutorial:
Photo Gallery Guide - How to Resize, Upload & Post Photos

I am moving this to abandoned journals until we get updates.

Thanks and hope all is well in your world!

Love and respect from all of us here at 420 Magazine!