souljaslim
New Member
Im creating my first grow room in my garage. Using a 2x4 insulated frame, the dimenstions are 4' x 14' x 6", OSB on the outside, sheet rock on the inside, gap sealed and painted with super white reflective roof paint.
3-Liquid Lumens With Wing
1-Grow Zone LS2 Light Timer 240V - 240V
3-1000W Digital Sol Ballast Non-Dimmable 240v
No Flow & Heat Detection Switch 1/2"
3-Solarmax 1000W HPS Bulb
1-C.A.P. Air-3 Temperature, Humidity & CO2 Controller
1-Hydro Innovations: HYDROGEN PRO WATER COOLED CO2 GENERATOR
ebb n flow
1-1/2 hp chiller
2-600gph pumps
1-65 gal res
1-portable a/c
1-standing osc fans
This is my first grow and im buliding it for the ground up. So Ive designed and run the manifold system, the power and I insulated the concrete floor just in case the temp effects my root system, who knows im new. The ballast and water supplies are located outside the room.
Then room is sealed i see no light entering from anywhere. Im running the pumps off a timer to my lights in a low pressure system running thru a no flow device that shuts everything down in case of a system leak or over heat. CO2 is connected to the manifold as well and is controlled along with the A/C by the temp/hum/co2 controller.
I ran the pumps for about a week, then I connected the CO2 and ran that to see if I could keep a consistent level of 1500 ppm. I am now in the process of running the complete system, So far so good, my room is running about a consistant 76 degrees. The temp outside ranges from 50 to 75 so i have little need for the chiller right now and im having trouble finding a constant dew point to stop the sweats. Ill take pictures soon.
Looking for suggestions, what do you think?
3-Liquid Lumens With Wing
1-Grow Zone LS2 Light Timer 240V - 240V
3-1000W Digital Sol Ballast Non-Dimmable 240v
No Flow & Heat Detection Switch 1/2"
3-Solarmax 1000W HPS Bulb
1-C.A.P. Air-3 Temperature, Humidity & CO2 Controller
1-Hydro Innovations: HYDROGEN PRO WATER COOLED CO2 GENERATOR
ebb n flow
1-1/2 hp chiller
2-600gph pumps
1-65 gal res
1-portable a/c
1-standing osc fans
This is my first grow and im buliding it for the ground up. So Ive designed and run the manifold system, the power and I insulated the concrete floor just in case the temp effects my root system, who knows im new. The ballast and water supplies are located outside the room.
Then room is sealed i see no light entering from anywhere. Im running the pumps off a timer to my lights in a low pressure system running thru a no flow device that shuts everything down in case of a system leak or over heat. CO2 is connected to the manifold as well and is controlled along with the A/C by the temp/hum/co2 controller.
I ran the pumps for about a week, then I connected the CO2 and ran that to see if I could keep a consistent level of 1500 ppm. I am now in the process of running the complete system, So far so good, my room is running about a consistant 76 degrees. The temp outside ranges from 50 to 75 so i have little need for the chiller right now and im having trouble finding a constant dew point to stop the sweats. Ill take pictures soon.
Looking for suggestions, what do you think?