400W HPS + 200W LED placement in a 4x4 Tent

[Plantsinsocks]

I run a 4x4 tent with a 400W HPS and a 200W LED.

How would you place the lights in the tent?
Will it stress my plants if i move them everyday from one side of the tent to the other side?

 

[Billpopy79]

I run a 4x4 tent with a 400W HPS and a 200W LED.

How would you place the lights in the tent?
Will it stress my plants if i move them everyday from one side of the tent to the other side?

I run a 4x4 with a 400w HPS and 380w of led.
I built my led from strips so did a bit of research on the light spread of the HPS.

Assuming your HPS is using a standard batwing reflector it will spread furthest out sideways.
I would run the HPS length ways to the front of your tent set just back from center with your led also running length ways hanging almost right at the front of your tent.
It wouldn't hurt to change your plants around front to back once in a while.

 

[013]

Hey Plants,

Welcome to forums at 420! Lighting plan sounds ok but bear in mind - it’s not enough to monitor temp and rh in your tent, you must be able to control them both; so if the new light pushes your enviro up then you will need to compensate and bring it into alignment