gr865
Well-Known Member
Just completed the light stand for my 5 plant vertical screen winter grow. it sits over a 12" 3 speed fan blowing vertical and a secondary fan as needed.
Here is a pic of the lamp stand for the 400W HPS to fit over the fan, finished today.
Changing the height of the lamp will be done by changing the lengths of the 4 lamp braces, noted by the red arrows. I use a lot of PVC pipe in my biz and have tons of scrap from each job, so I will cut lengths at 2" progression. Should work well. I do not feel it will need to be raised more than 8 to 12" overall, but can go higher if needed.
Here is a pic of the overall setup. Screens were not complete when this picture was taken.
6" Can filter and 6" Vortex exhaust fan with an Ideal Air Variable speed controller. Air is drawn into the room via a 6" duct from an adjacent room will be able to heat or cool as needed. Air exits via ducting into the garage.
Here is a pic of the lamp stand for the 400W HPS to fit over the fan, finished today.
Changing the height of the lamp will be done by changing the lengths of the 4 lamp braces, noted by the red arrows. I use a lot of PVC pipe in my biz and have tons of scrap from each job, so I will cut lengths at 2" progression. Should work well. I do not feel it will need to be raised more than 8 to 12" overall, but can go higher if needed.
Here is a pic of the overall setup. Screens were not complete when this picture was taken.
6" Can filter and 6" Vortex exhaust fan with an Ideal Air Variable speed controller. Air is drawn into the room via a 6" duct from an adjacent room will be able to heat or cool as needed. Air exits via ducting into the garage.