HermitCrab
New Member
Hello all. I am having some difficulties getting the temperature correct in my new tent.
Here is what I have:
- Secret Jardin DR100
3.25x3.25x6 = 63.375 cm
- S&P TD-150
wired on the "High" setting (293CFM)
- Active Air Carbon Filter
- 400 watt air cooled hood (ballast is outside the tent)
- I am using one of the vent panels in the bottom of the tent for passive intake.
I have it set up as follows:
Filter -> hood -> Fan -> Exhaust
My temp is around 80-82.
Is the fan too small? I was sure the TD-150 would have been strong enough. The one issue I see is that my filter has a 4" flange, so I have to use a reducer on that side of my hood, while the rest of the flow uses 6" ducting.
Any suggestions?
I do have a bit of excess duct going to my hood so that I can raise and lower it. I could probably trim a bit more off. Do you think that would help at all?
Thanks for any help.
Here is what I have:
- Secret Jardin DR100
3.25x3.25x6 = 63.375 cm
- S&P TD-150
wired on the "High" setting (293CFM)
- Active Air Carbon Filter
- 400 watt air cooled hood (ballast is outside the tent)
- I am using one of the vent panels in the bottom of the tent for passive intake.
I have it set up as follows:
Filter -> hood -> Fan -> Exhaust
My temp is around 80-82.
Is the fan too small? I was sure the TD-150 would have been strong enough. The one issue I see is that my filter has a 4" flange, so I have to use a reducer on that side of my hood, while the rest of the flow uses 6" ducting.
Any suggestions?
I do have a bit of excess duct going to my hood so that I can raise and lower it. I could probably trim a bit more off. Do you think that would help at all?
Thanks for any help.