First time cloner neep advice

[rasalibre]

earlier in the day i couldnt wait any longer so i decided to take a few cuttings from my mother xj13 plant. i took 5 cuttings and planted them using 1.5" rockwool cubes and rootech cloning gel solution. I was curious as to what foilar sprays are availible on the market and any other gizmo that i could benefit from using. I used cutting edge solutions and i plan on running the 6 bottle solution again. HOWEVER there is a foilar spray solution that i can make. Should i use this, or go with a store bought brand? HAPPY TOKING

 

[Ganjahoarder]

From experience and what I have learned here, clones only need to b sPrayed w ph water.

 

[rasalibre]

is it typical for the plants stock to get real flimsy in the first few days?

 

[SmokzAlot]

No worries, perhaps ease up just a tad on humidity. My vents usually stay closed for the first week. Open a vent a little bit if you think its excessive. Make sure you remove the cover at least twice a day to air exchange. Wilting to a point is normal. No intense direct lighting required either.

 

[rasalibre]

i have a heat mat and im curious as to what temps are suitable for healthy root development inside the dome. its lingering around 100 degrees and im not to sure what my humidity is because i think my thermometer is broken, but ive been trying to keep it humid in there with a little mister

 

[SmokzAlot]

I believe 78-82 F is acceptable. I use no heat mat at all. I dont sit it on cold surface or in a draft.