Had some freebie seeds on a recent order from True North. So, in the true spirit of waste not, want not, I'm going to do a one-off run off two autos while I finish up the new RDWC build and wait out that photo period grow. So this should be cured and ready around the 3rd-ish week of December, give or take, while the big grow won't be ready to use for a couple months after that.
So why not give some free autos their day in court?
Here we go.
Strains:
Auto Lemon Drop
Sweet Tooth Auto
Setup:
- 24x48x60 tent
- 365w (from the wall) Blurple LED
- Promix HP
- 5gal fabric smart pots (Gro Pro 5gal, w/ handles)
- 18" saucers
- 16" risers
Nutrients:
- Advanced Nutrients Sensi Coco Grow (both A&B, Grow and Bloom)
- Advanced Nutrients Big Bud Coco
- Advanced Nutrients Bud Candy
Watering:
Water/nutes to be delivered by an auto watering system. 15 gal res with a small pump, 1/2in flex tube runs out with 1/4in runs to drippers.
Pump will be on a timer that can do up to 3 cycles per day, with a 1sec minimum for each cycle. While the seeds sprout, I'll be checking out the pump setup to see how much it will push out and dial that in. The drips are adjustable so between the pump adjustment and the dripper adjustment it shouldn't be too terrible. Not like it will be using a ton of water initially anyway.
Seeds will hit the water, then into a rapid rooter. RR will be put into my cloner/sprouter dome, with a heat mat underneath of it. For the first bit while they sprout, will use a 2-bulb T-5 shop light.
Seeds hit the water tomorrow: 10/2/19
So why not give some free autos their day in court?
Here we go.
Strains:
Auto Lemon Drop
Sweet Tooth Auto
Setup:
- 24x48x60 tent
- 365w (from the wall) Blurple LED
- Promix HP
- 5gal fabric smart pots (Gro Pro 5gal, w/ handles)
- 18" saucers
- 16" risers
Nutrients:
- Advanced Nutrients Sensi Coco Grow (both A&B, Grow and Bloom)
- Advanced Nutrients Big Bud Coco
- Advanced Nutrients Bud Candy
Watering:
Water/nutes to be delivered by an auto watering system. 15 gal res with a small pump, 1/2in flex tube runs out with 1/4in runs to drippers.
Pump will be on a timer that can do up to 3 cycles per day, with a 1sec minimum for each cycle. While the seeds sprout, I'll be checking out the pump setup to see how much it will push out and dial that in. The drips are adjustable so between the pump adjustment and the dripper adjustment it shouldn't be too terrible. Not like it will be using a ton of water initially anyway.
Seeds will hit the water, then into a rapid rooter. RR will be put into my cloner/sprouter dome, with a heat mat underneath of it. For the first bit while they sprout, will use a 2-bulb T-5 shop light.
Seeds hit the water tomorrow: 10/2/19