- Thread starter
- #221
Locking ring is done
3D printed items for grows
- Thread starter Absorber
- Start date
- Thread starter
- #222
Does that bracket stretch a bit to allow for the splitter?
- Thread starter
- #224
Yea plenty of room for the tee piece if that's what you mean
- Thread starter
- #225
- Thread starter
- #226
So I received a 250mm inline silenced extraction for free so im printing 250mm to 150mm adapters for it
- Thread starter
- #227
Still printing
Yikes! How long does that part take?
- Thread starter
- #229
30 hrs
Yikes, yikes!
- Thread starter
- #231
In the world of 3d printing thats not too bad . What really sucks is when you get to 28hrs and then get a failure or run out of filament without noticing and print finishes and a bit of it is missing
then you have to start over- Thread starter
- #232
Ok I jinxed myself the other day I ran out of filament and missed it by 1 layer line as you can see the gap in the 3rd picture so I started it again , the end result is the first picture i trimmed the overall length of the print and reduced the print time to 15hrs
- Thread starter
- #233
Fits
phew
phew
Greenvein
Well-Known Member
PerfectFits
I take it once it's moulded you can't reuse the material?
And how does it hold up over time? I know in the plastics world they sometimes use stiffiners depending on the application, though maybe the same applies in this process?
- Thread starter
- #236
This is why I print with ABS Info here it lasts and can handle the real world .
Most plast appliances use it
Most plast appliances use it
- Thread starter
- #237
You can shred it and put it through a filament making machine ( you can make em ) but i can't be botheredPerfect
- Thread starter
- #238
Just had to rebuild the printer head she kept getting blockages it would stop extruding randomly.
Its been a long time since I've had to touch it so it was due for some maintenance, fingers crossed its sorted the issues out
Its been a long time since I've had to touch it so it was due for some maintenance, fingers crossed its sorted the issues out
- Thread starter
- #239
Seems to have fixed it
- Thread starter
- #240
The hotend rebuild has done the trick, she's not missing a beat now
Similar threads
