Need help with cloning please.

[prodotype]

Ok iv red the sticky how to clone a cannabis plant. Im using rockwool starter
plugs, the question is what PH should my rockwool be and what PH should
my clone sprayer bottle be? Im trying to clone hashberry and 8 miles high
both from mandala seeds any help would be grate.Thank you all who respond.

 

[420fied]

Pre-soak your rock wool plugs in water PH'd at 6. Same for the spray bottle.

Remember to use some rooting powder or gel. Also, make sure you get them into a cup of water as soon as you clip them.

 

[prodotype]

Thank you 420fied for the reply your help is much appreciated.
Congrats on the member and plant of the month.

 

[SciFi]

I've tried several rooting powders, but the only thing I got to work well, was Clonex. I don't know why.

My current cloning setup, I have better luck with bigger clones for some reason then smaller ones. I've got a seedling tray with a 6" dome. I mix up 1 gallon at 300ppms, pour into the tray, stick a long bubblestone in it, and sit my rockwool in there (after it's been treated). Cut from the plant, trim the leaves, recut my 45 degree angle across the internode, dip in clonex, and put in a pre-made hole in the rockwool about a half inch deep. In about a week I'll have some roots showing. Also.. someone pointed this out to me, and I started doing it, but make sure you're putting the cloning powder/gel on about 1/4" ABOVE the internode too.



Also, I've read 0 nutes in the water, and other people say at least 250ppms in the water and yet more say 1/4 strength. I personally had no luck at all cloning with 0 nutes, or bubblecloners, hempy bucket cloning, dirt cloning, perilite cloning, etc.
Might be my strain is a PITA thou.

Good luck.