Help with IWS controller wire connection

[gadpipe]

Hi all. I got given an iws controller with seconds control. Problem is I didn't get a cable with it. I need to know which wires to connect to which terminals inside. Can anyone help please. Without this help I think the unit is un-usable. Or maybe not. Anyone got the time to assist?

 

[bluter]

i think some are digital, some mechanical.
a pic and the brand would probably go a long way.

if you research the manufacturer you might even get a schematic.

 

[gadpipe]

i think some are digital, some mechanical.
a pic and the brand would probably go a long way.

if you research the manufacturer you might even get a schematic.

Thanks bluter.
I will get a pic tomorrow.
Thx for the quick response. Respect

 

[gadpipe]

Thanks bluter.
I will get a pic tomorrow.
Thx for the quick response. Respect

Here's a pic of the front and back. You can see the connection terminals marked 1-7 as far as I can see. Any advice will be appreciated.

 

[bluter]

yup. that's a wire block for sure.

do you have anything resembling an external connector ?
just judging from the block i would say it probably utilizes a 7 pin xlr or dmx connector.

there a couple different types. some push in, others have a screw connector. they are most commonly found in audio and lighting production. that's about as far as i can help.

 

[gadpipe]

Hi Bluter
Got it sorted
1:live in
2:negative in
3:fill pump live
4:drain pump live
5:1 wire from top float
6:1 wire from bottom float
7:2nd wire from both floats.
Both pumps negative wires joined by terminal block with power in lead in separate casing.
Thanks for your help still.