Lowrider72
Well-Known Member
Hey guys, Lowrider72 here.
Just thought I would share an easy tutorial for loading Yocan Evolve pens with our favourite concentrate....ROSIN.
Now anyone whos tried to load Rosin over coils knows its a pain... But I found a lil trick that will make life HEAPS easier.
Lets get started then.....
First we need a Quad coil beast pen....
Then we need some Rosin and a tool.....
Then a cheap Torch lighter.....
Take one Yocan Evolve Plus XL pen....
Remove magnetic mouthpiece and unscrew the carb cap to expose coils.....
Take tool heaped with Rosin and deposit by scraping off on the inside of top of coil section, like so....
Take one Torch lighter and heat the outside in short 3-5 second bursts..... until Rosin run down slowly and coats coils.....
Should end up looking like this with all 4 coils coated in Rosin......
This has made a HUGE difference to loading ease for me. Also the taste lasts longer as no coil runs low before the other.
Best taste on vape is also short bursts, 5-7 seconds max, prolonged seems it just burns, short bursts after initial heat up flows the concentrate back into the coils.
I use with air vents 1/2 to Full open to keep temps down on draw.
Always! keep the pen upright to coat Quad coils evenly while using pen.
Bit bigger than a standard pen but hits hard. Great for Rosin makers.
Enjoy!
Lowrider72
Just thought I would share an easy tutorial for loading Yocan Evolve pens with our favourite concentrate....ROSIN.
Now anyone whos tried to load Rosin over coils knows its a pain... But I found a lil trick that will make life HEAPS easier.
Lets get started then.....
First we need a Quad coil beast pen....
Then we need some Rosin and a tool.....
Then a cheap Torch lighter.....
Take one Yocan Evolve Plus XL pen....
Remove magnetic mouthpiece and unscrew the carb cap to expose coils.....
Take tool heaped with Rosin and deposit by scraping off on the inside of top of coil section, like so....
Loading Rosin to SIDE of coil chamber.
This prevents coil damage from tools and is easier.
Take one Torch lighter and heat the outside in short 3-5 second bursts..... until Rosin run down slowly and coats coils.....
Flames warm the Rosin and it flows down over coils.
Short bursts of 4-5 seconds, just enough for rosin to flow.
Should end up looking like this with all 4 coils coated in Rosin......
Coils covered in Rosin- an even coating.
Loading Evolve Plus XL like this covers coils equally and makes for better flavour.
This has made a HUGE difference to loading ease for me. Also the taste lasts longer as no coil runs low before the other.
Best taste on vape is also short bursts, 5-7 seconds max, prolonged seems it just burns, short bursts after initial heat up flows the concentrate back into the coils.
I use with air vents 1/2 to Full open to keep temps down on draw.
Always! keep the pen upright to coat Quad coils evenly while using pen.
Bit bigger than a standard pen but hits hard. Great for Rosin makers.
Enjoy!
Lowrider72