Making a version of Emilya's DIY Tupperware Bubble Cloner. @Emilya
1. Tupperware with lid taped. To make a cleaner hole.
2. Finished lid on one side.
3. Taping the bottom of the tupperware to block light.
4. Taping the bottom of the lid and drilling a small center holes. To make a cleaner holes.
5. Holes from the top to guide drill making 2" holes. I forgot to get a picture of the hole saw bit.
6. Cloner shown with 2" holes cut. Small holes drilled around two inch holes to moisturize clone tops. Air stone glued to bottom of tub with tubing attached to small air pump. I will use 2" net pots w/lips and 2" pucks. They are on order.
1. Tupperware with lid taped. To make a cleaner hole.
2. Finished lid on one side.
3. Taping the bottom of the tupperware to block light.
4. Taping the bottom of the lid and drilling a small center holes. To make a cleaner holes.
5. Holes from the top to guide drill making 2" holes. I forgot to get a picture of the hole saw bit.
6. Cloner shown with 2" holes cut. Small holes drilled around two inch holes to moisturize clone tops. Air stone glued to bottom of tub with tubing attached to small air pump. I will use 2" net pots w/lips and 2" pucks. They are on order.