VanIslandConnoisseur
Well-Known Member
what is that?? please explain in detail#MarshydroFC6500
Will keep the roots cool from the basting 650 watt light with this.
super interested
Looking For Winner: Mars Hydro FC6500 Giveaway！
- Thread starter Mars Hydro
- Start date
super interested
Kushgrow3579
Well-Known Member
Alright haha, I will let you know in the future if i do decide to make them and if i have enough to sell some. At the same time i definitely don't want to end up like Marc Emery did shipping seeds from Canada to the US too though so would have to check laws about exporting cannabis seeds aswell lol.
Smokey0418
Well-Known Member
@VanIslandConnoisseur
That is a 1/2 stainless wort coil.
There are a few instructions on YouTube.
What I have done is taken a 5000 btu air conditioner and bent the cooling coil out of the back and put it into a Coleman cooler.
Conditioner was stripped of controls and just kept what’s needed. Wire without a switch so it just comes on high and then trimed a couple inches from the back so it could have more room to the cooler for the coil.
This is turn has been filled with a glycol and water mixture .
I then use an inkbird thermostat to turn the conditioner on and off at a set temp with a 1 degree offset.
Probe in a bucket in the tent.
The cycle is 2 1/4 hrs, it take 42 minutes to cool then runs 1 1/2 hrs off the cooled water .
There is a 396 gph pump that runs all the time cycling the cooled mixture through the coil.
Temp cycles from 68.2 to 66.6 . It stops at 67 but cools lower as I can’t set a decimal degree , but it reads in decimal.
Cooling 35 gallons
Overall I am quite happy with this set up.
That is a 1/2 stainless wort coil.
There are a few instructions on YouTube.
What I have done is taken a 5000 btu air conditioner and bent the cooling coil out of the back and put it into a Coleman cooler.
Conditioner was stripped of controls and just kept what’s needed. Wire without a switch so it just comes on high and then trimed a couple inches from the back so it could have more room to the cooler for the coil.
This is turn has been filled with a glycol and water mixture .
I then use an inkbird thermostat to turn the conditioner on and off at a set temp with a 1 degree offset.
Probe in a bucket in the tent.
The cycle is 2 1/4 hrs, it take 42 minutes to cool then runs 1 1/2 hrs off the cooled water .
There is a 396 gph pump that runs all the time cycling the cooled mixture through the coil.
Temp cycles from 68.2 to 66.6 . It stops at 67 but cools lower as I can’t set a decimal degree , but it reads in decimal.
Cooling 35 gallons
Overall I am quite happy with this set up.
VanIslandConnoisseur
Well-Known Member
#MarshydroFC6500
tent pics 2.5hrs ago pine warp and timewarp, mini-me's
tent pics 2.5hrs ago pine warp and timewarp, mini-me's
VanIslandConnoisseur
Well-Known Member
more "Marshydro6500"
VanIslandConnoisseur
Well-Known Member
check those pistils wrapped around the leaf like crab legs
i just smoked a J of Tom Ford Pink Kush with my brother and i am ripped
i just smoked a J of Tom Ford Pink Kush with my brother and i am ripped
Gabby987
Well-Known Member
#MarsHydroFC6500
@MarshydroFC6500
Hulkberry, aka, Bruce Banner #3 x Bruce Banner #3, on day 13 of flower.
Hulkberry, aka, Bruce Banner #3 x Bruce Banner #3, on day 13 of flower.
bassman5420
420 Member
#MarshydroFC6500
Woo buddy! I bet that light is a beast!
Woo buddy! I bet that light is a beast!
bassman5420
420 Member
#MarshydroFC6500
PBBx? hogging the whole tent
PBBx? hogging the whole tent
East Coast Marley420
Well-Known Member
#MarshydroFC6500
Serenity in that pic Marley#MarshydroFC6500
Kushgrow3579
Well-Known Member
Think i am going to make some bubble hash and maybe a little rosin today or tomorrow #MarsHydroFC6500
That's tightcheck those pistils wrapped around the leaf like crab legs
i just smoked a J of Tom Ford Pink Kush with my brother and i am ripped
Moony
Well-Known Member
Day 9 entry 9 picture 9
I've picked 1 of the smaller buds and trimmed it. This will be my first taster of my blue gelato 41 in a week's time. The rest comes down this weekend. Also wanted to show the TSL2000 off
Hope I can use the power of the #MarshydroFC6500 for my next run
I've picked 1 of the smaller buds and trimmed it. This will be my first taster of my blue gelato 41 in a week's time. The rest comes down this weekend. Also wanted to show the TSL2000 off
Hope I can use the power of the #MarshydroFC6500 for my next run
VanIslandConnoisseur
Well-Known Member
#MarshydroFC6500
2 of 2 mini Pinewarp
Tiny but mighty!!
2 of 2 mini Pinewarp
Tiny but mighty!!
Moony
Well-Known Member
Looking good but I think 1 picture a day is probably enough hahah#MarshydroFC6500
2 of 2 mini Pinewarp
Tiny but mighty!!
Ganjagrandaddy
Well-Known Member
How the #1 northern lights finished pre trim sp3000.
And a nice Gorilla cookies nug too
#MarsHydroFC6500
And a nice Gorilla cookies nug too
#MarsHydroFC6500
Similar threads
