- Thread starter
- #41
Skybound
Well-Known Member
My filter is a little junk one, and I am planning to run 2 different rooms through it so once I get another in Bloom (hope tomorrow or Sunday) and things start stinking, it'll be 24 hours nonstop deStinkification going on up in there. I flipped it upside down as there was not enough room above the RO res and of course I failed to plan things out a bit more. Had I poked the 6" holes just a few inches higher, I could've blown the air down. Now it looks real busy up top. I still need to figure out how to block light through the ducting because the Wye only blocks about half the light. I'm thinking to run some flex hose from the wall port to above the light. I'm thinking the bends in the hose + being on top of the reflector might give me a cheap fix. If it works, the upside I guess would be that air is then being drawn off the top of the room instead of the current midway point.
Another nugget of good news is that I just finished the code to control a single dosing pump via my cell phone. Just need to figure out how to duplicate the code to account for the other 7 pumps. At any rate, I foresee my days of drawing nutes from a bottle with syringes will soon be coming to an end. The days of "dial a dose" is extremely near. Life will then get a lot easier.
Another nugget of good news is that I just finished the code to control a single dosing pump via my cell phone. Just need to figure out how to duplicate the code to account for the other 7 pumps. At any rate, I foresee my days of drawing nutes from a bottle with syringes will soon be coming to an end. The days of "dial a dose" is extremely near. Life will then get a lot easier.