Hello Everyone,
I've decided to take the plunge and start doing this for myself!
I currently have not started the process and will be creating further threads in the relevant forums when I do start.
My setup specs are as follows
4x4 gorilla tent
Autopot x4: 12.4 Gallon Reservoir with 3.9 Gallon pots
AC Inline T4 - model# AICLT4
ROI-E420 LED lights
1x clip fan
I've run the system without plants for a week to gauge temperatures. I have the Lights as high up in the tent as I can and can adjust the lights from 25%, 50%, 75%, and 100% intensity.
It's very stable from what I can tell so far at 72-80 degrees from 25%-100% with fan settings from 1 through 10 with RH going from 35%-55%
I've purchased Photo(F) Gorilla Glue seeds from a reputable seedbank
my plan so far:
-Some LST to try and maximize yield by doing a spiral around my grow pots (throughout the seedling/veg phase). I'll be trying mainline topping (as suggested below by User: Just a Simple Guy) (I'm not sure how to call other users in a thread yet but I'll see if I can figure that out.)
- 1" of PH neutral clay pebbles at the bottom of the pots with the rest being filled with a coco/perlite mix.
- Fill reservoir and get PH balance to 6.0
- Use 6.0 PH water to Germinate
- After germination, place the seedlings into solo cups with my coco/perlite mix (cut bottom cup out) planted in end pots.
- Water inside solo cup using water from reservoir
- After 6-10 days remove solo cup (carefully without disturbing roots). Turn on tap so Autopot system starts working.
- Pay attention and test morning and nightly.
If anyone sees any glaring problems with my plan or has any advice I would be greatly appreciative!
I have done a lot of research so far and I would like to keep things as much in my control as possible which is why I'm going for PH neutral grow mediums, etc.
Thank you!!
I've decided to take the plunge and start doing this for myself!
I currently have not started the process and will be creating further threads in the relevant forums when I do start.
My setup specs are as follows
4x4 gorilla tent
Autopot x4: 12.4 Gallon Reservoir with 3.9 Gallon pots
AC Inline T4 - model# AICLT4
ROI-E420 LED lights
1x clip fan
I've run the system without plants for a week to gauge temperatures. I have the Lights as high up in the tent as I can and can adjust the lights from 25%, 50%, 75%, and 100% intensity.
It's very stable from what I can tell so far at 72-80 degrees from 25%-100% with fan settings from 1 through 10 with RH going from 35%-55%
I've purchased Photo(F) Gorilla Glue seeds from a reputable seedbank
my plan so far:
-
- 1" of PH neutral clay pebbles at the bottom of the pots with the rest being filled with a coco/perlite mix.
- Fill reservoir and get PH balance to 6.0
- Use 6.0 PH water to Germinate
- After germination, place the seedlings into solo cups with my coco/perlite mix (cut bottom cup out) planted in end pots.
- Water inside solo cup using water from reservoir
- After 6-10 days remove solo cup (carefully without disturbing roots). Turn on tap so Autopot system starts working.
- Pay attention and test morning and nightly.
If anyone sees any glaring problems with my plan or has any advice I would be greatly appreciative!
I have done a lot of research so far and I would like to keep things as much in my control as possible which is why I'm going for PH neutral grow mediums, etc.
Thank you!!