- Thread starter
- #81
Mikeytv
New Member
They are growing pretty fast. Question, when do I stop tucking?
Sent from mikeytv
Sent from mikeytv
How To Use Progressive Web App aka PWA On 420 Magazine Forum
Note: This feature may not be available in some browsers.
Tuck a little longer then let them go vertical. How much room do you have between your light and the scrog?
StarKiller OG - Rockwool - Ebb & Flow - 1200W LED - 2016
New Member Start Links
How do I top my plants?
Auto Growers Unite - A Community Thread
You could let them go vertical now just watch for any branches that want to shoot up taller than the rest.
StarKiller OG - Rockwool - Ebb & Flow - 1200W LED - 2016
New Member Start Links
How do I top my plants?
Auto Growers Unite - A Community Thread
Wait until you actually have pistils showing and upward growth has pretty much stopped then remove any fans blocking bud sites. What youre going for is what ends up above your net.
StarKiller OG - Rockwool - Ebb & Flow - 1200W LED - 2016
New Member Start Links
How do I top my plants?
Auto Growers Unite - A Community Thread
Everyone is doing well. Girls are thriving. Had a question on light distribution. Would two 400 hps set ups be better for such this small grow? These 3 share with dwc set up that takes up about the same square footprint. Total is 4x2. That's not the total space but the space of the scrog/canopy.
I was thinking of reducing the ballasts to 250 each and give each half its own 250 hps. Seems this would net more light but then I wonder am I just going to waste light/energy at that point. Thoughts? Heat is under control currently. Not sure if it will be a major issue with additional hps.
Not sure what else to do except just leave them alone - aside from feeding/water/light. Wasn't sure if I needed to trim again as I am in flower- about 2 weeks in.
Sent from mikeytv
I keep defol to a minimum, only leaves that are blocking lower bud sites get trimmed.
StarKiller OG - Rockwool - Ebb & Flow - 1200W LED - 2016
New Member Start Links
How do I top my plants?
Auto Growers Unite - A Community Thread
If you can go with 2 x 400 watt hps, that'd be the best, remember you can keep 400 watt lights stupidly close, keep them as close as possible, also don't remove fan leafs or any leaf for that matter (unless it's dead) if you keep your 400 watt close enough (within 5 inches), light still penetrates the lower canopy, more so with the infared spectrum, which actually signals the underbrush to grow tall to get to the light. Also fan leafs are very very important, even when you mainline from the start, try to leave the fan leafs at all times.
Could you guys take a look and tell me what I should be doing or if I'm on the right track. Also a couple are from seed others are clones - this accounts for different in growth patterns.
Wondering about leaving the little sites along the branch or should I remove all.
Thanks
Sent from mikeytv
Only 1 month ago. It's awesome how fast things can change when you run them like machines.